How to make EMP Jammer [ Step by Step ]

These are the components required this. is the schematic now remove the screws of mosquitoes wrapper and then remove the case, discharge immediately of the psyche. now these solder the wires off is the upper and then they solidly charging in. to go while this is the high voltage generator Institute this is the capacitor which generate the high voltage okay now we move the charging right it is optional you can keep it if you want to charge you take a half meter.

hookup wire and make coil as shown in this video this is the high voltage. change register cube we take a small gap at any one of the 10 min of output capacitor and then connect one wire of coil agree spot them and connect another wire of the coil directly to the another pin memorize the output capacitor when the circuit is on we can see the spot here according to Samadhi shoulder one inner of the coil at one tenure of the capacitor to create spark gap blue D Y near to the capacitor dinner at a distance or.

pooping limiters or less than it now you can see the generation of this pot at, the spark gap which is created now solder the wires for the external switch now place the circuit in the case. carefully and don't forget to turn on the switch before close indicate so. apply some glue to the case and fix this wish to apply double-sided tape to fix, feedback fish now solder the wires to the external switch now we test it we can see this watch is reset when we on the EMP jammer this on it, yes it's changing to one thank you for watching subscribe for more videos